Kingston KC600 1TB vs Lexar NS100 1TB
At least one of these has no price the site currently tracks, so what follows weighs specifications alone.
| Specification | KingstonKC600 1TB | LexarNS100 1TB |
|---|---|---|
| Capacity (GB) | 1000 | 1000 |
| Sequential read (MB/s) | 550 | 550 |
| Sequential write (MB/s) | 520better | 500 |
| Current best price | — | 136,99 €at Amazon.fr · captured 2026-09-13 |
| Price per TB | — | 136,99 € |
| Endurance (TBW) | 600better | 512 |
| Warranty (years) | 5better | 3 |
| DRAM cache | Yes | — |
| NAND type | tlc | tlc |
| Controller | Silicon Motion SM2259 | Marvell 88NV1120 |
How these two compare
Sequential throughput
Kingston KC600 1TB reads at 550 MB/s and writes at 520 MB/s; Lexar NS100 1TB reads at 550 MB/s and writes at 500 MB/s. Both ride the SATA bus, which caps sequential transfer near 550 MB/s in either direction — the ceiling every SATA drive works against — so what more decisively separates them is sustained and random behaviour, the DRAM cache, and endurance.
Endurance
Kingston KC600 1TB is rated for 600 TBW and Lexar NS100 1TB for 512 TBW — the total the maker warrants you can write over the drive's life. A typical desktop writes only a few terabytes a year, so either rating is many years of headroom; the figure matters mainly as a relative signal of how hard each is built to be driven.
DRAM cache
On the cache question: Kingston KC600 1TB carries a DRAM cache, and the catalog does not state whether Lexar NS100 1TB carries a DRAM cache. The DRAM keeps the flash-translation table close, sparing a lookup on nearly every access; a drive without it leans on host memory or its own flash, which usually shows as slower sustained random writes rather than in the headline sequential numbers.
NAND, controller and warranty
On the flash itself: Kingston KC600 1TB uses TLC, and Lexar NS100 1TB uses TLC. NAND tiers count bits per cell — more bits pack more capacity into the same silicon but shorten write endurance and slow sustained writes, which is why QLC sits below TLC on lasting performance even when the sequential numbers match. Controller: Kingston KC600 1TB uses the Silicon Motion SM2259 and Lexar NS100 1TB uses the Marvell 88NV1120. The controller runs wear-levelling, error correction and the mapping table, so it shapes sustained and random behaviour as much as the flash does — though the model name alone predicts little without testing. Kingston KC600 1TB carries a 5-year warranty and Lexar NS100 1TB carries a 3-year warranty — the length the maker will stand behind the drive, and usually a proxy for the endurance it is rated to.
Which to buy
The site holds no current price for at least one of these, so it cannot call the buy on cost. Judge them on the specifications above — at the same capacity and interface, two drives usually part on things like the DRAM cache, the NAND tier, endurance and warranty, so weigh whichever of those the sections above report.
Common questions about this pair
- Which is faster, Kingston KC600 1TB or Lexar NS100 1TB?
- Kingston KC600 1TB reads at 550 MB/s and writes at 520 MB/s; Lexar NS100 1TB reads at 550 MB/s and writes at 500 MB/s. Both ride the SATA bus, which caps sequential transfer near 550 MB/s in either direction — the ceiling every SATA drive works against — so what more decisively separates them is sustained and random behaviour, the DRAM cache, and endurance.
- Should you buy Kingston KC600 1TB or Lexar NS100 1TB?
- The site holds no current price for at least one of these, so it cannot call the buy on cost. Judge them on the specifications above — at the same capacity and interface, two drives usually part on things like the DRAM cache, the NAND tier, endurance and warranty, so weigh whichever of those the sections above report.