ASUS ROG Thor Platinum III Spec and Price in Italy
Thor Platinum III is the ASUS unit you buy for the panel on its side: a magnetic OLED display reads out real-time power draw and detaches so it faces outward whether the supply is mounted fan-up or fan-down. Underneath it is a GaN-based 80 PLUS Platinum design, 92% efficient at half load and 89% at full, built to ATX 3.1 with a native 16-pin PCIe 5.1 cable. The PWM fan runs on dual ball bearings and stops below 30% load, which is where the Cybenetics Lambda A++ noise grade comes from. Aura Sync lighting, seven SATA connectors, and ten years of warranty at 1000W and 1200W.
Prices include VAT.
The last tracked price for the 1000W ASUS ROG Thor Platinum III in Italy was 374,00 € at Amazon.it, captured 2026-10-12. Across one tracked merchant and 9 days of recorded prices, the 90-day median for the 1000W ASUS ROG Thor Platinum III is 384,40 € and the lowest recorded price is 269,99 €. This site began capturing prices on July 30, 2026; for Amazon listings, prices dated earlier come from Keepa's price history.
Captured periodically and may have changed.
- 1000W
- 1200W
Each point is one day's recorded price, not a list price. Points dated before July 30, 2026, when this site began capturing prices, come from Keepa's Amazon price history. How we track prices
Specifications
- Wattage
- Efficiency
- 80 Plus Platinum
- Form factor
- ATX
- ATX version
- 3.1
- Zero-RPM mode
- Yes
- 12V-2x6 connectors
- 1
- PCIe 8-pin
- 4
- SATA connectors
- 7
- Warranty
- 10 years
Wattages
| Configuration | Part number | Current best price |
|---|---|---|
| 1000W | — | 374,00 € Price too old to confirm |
| 1200W | — | 414,40 € Price too old to confirm |
What owners and reviewers say
Summarised from 1 source(s), reviewed September 14, 2026. A source is counted only where it names this model exactly. How we track prices
Commonly praised
- Reviewers found good parts, high overall efficiency, silent operation, and a long hold-up time, with extra-long EPS and PCIe cables.
- It is ATX 3.1 and PCIe 5.1 compliant, uses a quality dual-ball-bearing fan, and provides a 600W 12V-2x6 connector.
Commonly criticised
- Its over-current and over-power protections need adjustment and there is no fan-failure protection, and the sample's soldering quality was low.
- It has high inrush currents, low efficiency at light loads, and mediocre 3.3V transient response.
- The 1000W model ran noisier than the 1200W model of the same family.
Sources behind this summary
Guides for this category
Sources
Every spec above was pulled from one of these — a field a source didn't state was left off rather than estimated.