Lexar NS100 Spec and Price in Italy
Built around a Marvell 88NV1120 controller, the NS100 is Lexar's SATA-tier entry, rated at 550/500 MB/s sequential with TLC NAND and a 512TB write endurance figure over a 3-year warranty. Compared to the NM790's PCIe 4.0 numbers, it's a generation and an interface behind, making it a fit for older systems, budget rebuilds, or anyone replacing a failing hard drive rather than chasing NVMe speeds.
Tied 96th of 106 models in the SSD catalog on Sequential read — 4 models share this figure. Tied 99th of 106 models in the SSD catalog on Sequential write — 4 models share this figure.
No tracked price — this page compares specifications alone.
Specifications
- Capacity
- 1TB
- Interface
- SATA
- Sequential read
- 550 MB/s
- Sequential write
- 500 MB/s
- Form factor
- 2.5-inch
- NAND type
- TLC
- Controller
- Marvell 88NV1120
- Endurance (TBW)
- 512 TB
- Warranty
- 3 years
Capacities
| Configuration | Part number | Endurance (TBW) | Sequential write | Sequential read |
|---|---|---|---|---|
| 128GB | LNS100-128RBNA | 64 TB | 500 MB/s | 520 MB/s |
| 256GB | LNS100-256RBNA | 128 TB | 500 MB/s | 520 MB/s |
| 512GB | LNS100-512RBNA | 256 TB | 500 MB/s | 550 MB/s |
| 1TB | LNS100-1TRBNA | 512 TB | 500 MB/s | 550 MB/s |
| 2TB | LNS100-2TRBNA | 1000 TB | 500 MB/s | 550 MB/s |
Guides for this category
What owners and reviewers say
Summarised from 1 source(s), reviewed September 14, 2026. A source is counted only where it names this model exactly. How we track prices
Commonly praised
- Reviewers measured sequential reads at the advertised SATA ceiling and consistent burst performance.
- It uses TLC NAND and is covered by a three-year warranty.
Commonly criticised
- As a DRAM-less SATA drive it is limited to roughly 550MB/s, far below NVMe alternatives.
- Measured write throughput fell noticeably short of its sequential read figure.
Sources behind this summary
Sources
Every spec above was pulled from one of these — a field a source didn't state was left off rather than estimated.