Skip to main content
G.SKILL

G.Skill Ripjaws V DDR4-3600 Spec and Price in Brazil

DDR42x16GBUDIMM8.89 ns true latency

Buyers chasing low latency at DDR4-3600 land on Ripjaws V, which pairs CL16 timings (16-19-19-39) with 1.35V — a true latency edge over Corsair's Vengeance RGB PRO, which runs the same 3600 MT/s speed at CL18. No RGB here, just a mainstream DDR4 kit built around that timings-to-speed ratio. Against G.SKILL's own Aegis DDR4-3200, Ripjaws V holds the same CL16 floor but at a 400 MT/s higher clock, with secondary timings (19-19-39) just one step looser than Aegis's 18-18-38.

Tied 102nd of 139 models in the RAM catalog on Speed — 8 models share this figure.

Current best price

No tracked price — this page compares specifications alone.

Specifications

Capacity
2x16GB
True latency
8.89 ns
Memory type
DDR4
Speed
3600 MT/s
CAS latency
Form factor
UDIMM
Voltage
1.35 V
Timings
16-19-19-39
Modules
2
RGB
No

Capacities

ConfigurationPart numberSpeedCAS latencyTrue latency
2x8GBF4-3600C16D-16GVKC
2x16GBF4-3600C16D-32GVKC3600 MT/s168.89 ns
2x16GB CL18F4-3600C18D-32GVK3600 MT/s1810.00 ns
2x8GB 3000 CL16F4-3000C16D-16GVRB3000 MT/s1610.67 ns
2x8GB 3600 CL18F4-3600C18D-16GVK3600 MT/s1810.00 ns
2x8GB 2400 CL15F4-2400C15D-16GVS2400 MT/s1512.50 ns
4x8GB 2666 CL19F4-2666C19Q-32GVR2666 MT/s1914.25 ns

Guides for this category

What owners and reviewers say

Summarised from 2 source(s), reviewed September 13, 2026. A source is counted only where it names this model exactly. How we track prices

Commonly praised

  • Terrific out-of-the-box performance and very receptive to overclocking, in a wide range of colours and capacities.
  • Owners report the modules hitting their rated speeds through XMP or the AMD memory profile on a wide range of Intel and AMD boards.
  • Owners consider them inexpensive for a 32GB CL16 kit and good value.
  • The absence of RGB and the short heatspreader, which clears large CPU coolers, are recurring points of praise.
  • Owners report further overclocking headroom beyond the rated profile with manual tuning.

Commonly criticised

  • Expensive at the time, and tightening timings at the stock speed proved difficult.
  • Owners note that some motherboards do not apply the XMP profile correctly and require manual timing and voltage entry.
  • An owner reports one stick in the first kit failing, with the replacement handled smoothly by the manufacturer.

Sources behind this summary

Sources

Every spec above was pulled from one of these — a field a source didn't state was left off rather than estimated.